Download My Document - Stemmer Imaging

Condition
Example
Left: Rising, void
Right: Falling, void
Left: Rising
Right: Data end, void
Left: Data end, void
Right: Falling
Left: Falling
Right: Rising
Strip Step Edge Definitions
The Strip tool detects step edges based on the parameters Base Type, Edge Transition Width, Edge
Support Width, and Minimum Edge Height.
When Base Type is set to Flat, the regions around the edges are visible and the edge positions are
between the base and the strip surface.
The Minimum Edge Height parameter defines the size of the step edge. The Edge Transition Width
parameter specifies the nominal width of the transition, from the base to the strip surface.
Gocator Measurement Tool Technical Manual
21