Download ECL2-V680D1

6. HOW TO COMMUNICATE WITH ID TAGS
6.4.5 Program example with QnACPU use
Set the parameters using "Network Parameters" of GX Developer.
(1) Parameter settings
(a) Setting the network parameters
Table 6.10 "CC-Link List Settings" Dialog Box Settings (with QnACPU Use)
Set Item
No. of boards in module
Start I/O No.
Type
All connect count
Remote input (RX) refresh device
Remote output (RY) refresh device
Remote register (RWr) refresh device
Remote register (RWw) refresh device
Special relay (SB) refresh device
Special register (SW) refresh device
Retry count
Automatic reconnection station count
Wait master station No.
PLC down select
Scan mode setting
Delay information setting
Station information setting
6 - 22
Set Value
1 (module)
0000
Master station
1 (station)
X1000
Y1000
D1100
D1000
B0
W0
3 (times)
1 (module)
0
Stop
Asynchronous
0
Refer to Section (1) (b) in this section.
6 - 22