Download Direct Sequence Spread Spectrum (DSSS) Receiver

Transcript
DSTO-GD-0525
2.1.3 JTAG
Designation : JTAG.
Location : DPC backpanel.
Type : 12-pin, 0.1” header.
Specifications : JTAG standard port.
Description : This connector provides access to both a 3.3V and a 1.5V JTAG chain. The 3.3V
chain accesses the DPC Mainboard FPGA and its configuration EEPROM. The 1.5V chain
accesses FPGAs on Slots 0 to 3. Pin assignments for 3.3V or 1.5V connectivity follow from the
DPC schematics Sheet “F1.3 BS-2”. A breakout cable is available.
2.1.4 LVDS Digital I/O
Designation : DDP-X1.
Location : DDP component-side.
Type : 84-pin SAMTEC high speed header (2 x 42 x 0.8mm).
Specifications : 17mΩ, 2.0A per contact typical. 8GHz sinusoidal signalling rate.
Description : Operates as either 42 LVDS-standard differential I/O channels or 84 LVCMOS
single-ended I/O channels. The DSSS FW configures the interface for 21 LVDS output
channels and 21 LVDS input channels.
2.1.5 PCI Bus Connector
Designation : DPC-X1.
Location : DPC card edge.
Type : 64-bit universal PCI edge connector.
Specifications : See “PCI Local Bus Specification, Revision 2.2”.
Description : The PCI physical interface supports 32/64-bit and 33/66 MHz transactions in
accordance with Revision 2.2 of the PCI Standard. The DPC PCI Target FW supports the
following transaction types from the standard :
C/BE[3::0]#
0110
0111
12
Command Type
Memory Read
Memory Write