Download User`s manual

Transcript
MCX314As/AL – M36
NOVA electronics Inc.
2.5 Automatic Home Search
This IC has a function that automatically executes a home search sequence such as high-speed near home search → low-speed
home search → encoder Z-phase search → offset driving without CPU intervention. The automatic home search function
sequentially executes the steps from step 1 to step 4 that are listed below. Set execution/non-execution and a search direction
mode for each step. In steps 1 and 4, search operation is performed at the high-speed that is set in the drive speed. In steps 2 and
3, search operation is performed at the low-speed that is set in the home search speed.
Step number
Operation
Search speed
Step 1
High-speed near home search
Drive speed (V)
Detection signal
nIN0
*1
nIN1
*1
Step 2
Low-speed home search
Home search speed (HV)
Step 3
Low-speed Z-phase search
Home search speed (HV)
nIN2
Step 4
High-speed offset drive
Drive speed (V)
-
*1: By inputting a home signal in both nIN0 and nIN1, high-speed search is enabled by using only one home signal.
(See “Example of home search using a home signal only” in Section 2.5.7).
HOME
(IN1)
Near HOME
(IN0)
Active
Section
Active
Section
Encoder Z-phase
(IN2)
Decelerating Stop
at Detection of
Near Home
Step 1
High -speed Near Home Search
Step 2
Low -speed Home Search
Step 3
Low -speed Z-phase Search
Step 4
High -speed Offset Drive
Instant Stop at Detection of Home
Instant Stop at Detection of Z-phase
Fig. 2.39 Prototype of Automatic Home Search Using This IC
2.5.1 Operation of Each Step
In each step, it is possible to specify, in mode setting, execution/non-execution and the +/− search direction. If non-execution is
specified, the function proceeds with the next step without executing the step.
Step 1: High-speed near home search
Drive pulses are output in the specified direction at
the speed that is set in the drive speed (V) until the
near home signal (nIN0) becomes active. To perform
high-speed search operation, set a higher value for the
drive speed (V) than the initial speed (SV).
Acceleration/deceleration driving is performed and
when the near home signal (nIN0) becomes active, the
operation stops by decelerating.
IN0
Normal Operation
Active
Section
Over Run Limit in the
Search Direction
Irregular (3)
Active
Section
Specified Search
Direction
Irregular (1)
Irregular (2)
Irregular operation
(1) The near home signal (nIN0) is already active before Step 1 starts. → Proceeds with Step 2.
(2) The limit signal in the detection direction is already active before Step 1 starts. → Proceeds with Step 2.
(3) The limit signal in the detection direction is activated during execution. → Stops driving and proceeds with Step 2.
– 36 –