Download User`s manual
Transcript
MCX314As/AL – M36 NOVA electronics Inc. 2.5 Automatic Home Search This IC has a function that automatically executes a home search sequence such as high-speed near home search → low-speed home search → encoder Z-phase search → offset driving without CPU intervention. The automatic home search function sequentially executes the steps from step 1 to step 4 that are listed below. Set execution/non-execution and a search direction mode for each step. In steps 1 and 4, search operation is performed at the high-speed that is set in the drive speed. In steps 2 and 3, search operation is performed at the low-speed that is set in the home search speed. Step number Operation Search speed Step 1 High-speed near home search Drive speed (V) Detection signal nIN0 *1 nIN1 *1 Step 2 Low-speed home search Home search speed (HV) Step 3 Low-speed Z-phase search Home search speed (HV) nIN2 Step 4 High-speed offset drive Drive speed (V) - *1: By inputting a home signal in both nIN0 and nIN1, high-speed search is enabled by using only one home signal. (See “Example of home search using a home signal only” in Section 2.5.7). HOME (IN1) Near HOME (IN0) Active Section Active Section Encoder Z-phase (IN2) Decelerating Stop at Detection of Near Home Step 1 High -speed Near Home Search Step 2 Low -speed Home Search Step 3 Low -speed Z-phase Search Step 4 High -speed Offset Drive Instant Stop at Detection of Home Instant Stop at Detection of Z-phase Fig. 2.39 Prototype of Automatic Home Search Using This IC 2.5.1 Operation of Each Step In each step, it is possible to specify, in mode setting, execution/non-execution and the +/− search direction. If non-execution is specified, the function proceeds with the next step without executing the step. Step 1: High-speed near home search Drive pulses are output in the specified direction at the speed that is set in the drive speed (V) until the near home signal (nIN0) becomes active. To perform high-speed search operation, set a higher value for the drive speed (V) than the initial speed (SV). Acceleration/deceleration driving is performed and when the near home signal (nIN0) becomes active, the operation stops by decelerating. IN0 Normal Operation Active Section Over Run Limit in the Search Direction Irregular (3) Active Section Specified Search Direction Irregular (1) Irregular (2) Irregular operation (1) The near home signal (nIN0) is already active before Step 1 starts. → Proceeds with Step 2. (2) The limit signal in the detection direction is already active before Step 1 starts. → Proceeds with Step 2. (3) The limit signal in the detection direction is activated during execution. → Stops driving and proceeds with Step 2. – 36 –