Download Now

Laipac Technology Inc.
5.2.5
StarFinder Lite User’s Manual & Reference Guide
Power Connector
The main Power supply voltage could work in the range of 9-36V. Typical power consumption of
the Starfinder Lite is 1W with peaks up to 5.5W. The current drawn is a result of power over
voltage, thus a low voltage power supply will need to provide more current.
5.2.6
Buttons Input/Output
These four connections are used by the StarFinder Lite Button/Analog cable set. If you are using
these without the standard cable set, the following summarizes the use of these connections.
Input BIO1 – Active LOW; will start, answer, or end a phone call (if enabled)
Input BIO2 – Active LOW; will send a Panic report to LocationNow (if enabled)
Output BIO3 – Normally LOW; indicates phone call status (used to drive LED)
GND – Common Ground
The inputs are standard 3.3V to signal a logical HIGH, and tolerant up to 5V; exceeding 5V can
damage your StarFinder Lite.
© 2012-2021 by Laipac Technology Inc. All Rights Reserved.
Page 35