Download Laser 30 (Type D) (E)

Transcript
Laser 30 (Type D) (E) 09.1.23 11:10 AM ページ 21
SAFETY TIPS FOR INSTALLATION
Follow the safety tips below when planning the installation of your Laser 30.
1.
Intake and exhaust flue pipe openings must be fully exposed to outside air.
Do not vent into chimney, garage, basement under the floor, or into any
enclosed area.
2.
Do not install flue pipe in close proximity to other objects or materials (See
page 22).
3.
Before making a hole in your wall for the flue pipe, make sure the area is free
of electrical wires, gas pipes and other obstacles.
4.
Do not install flue pipe where it will be exposed to heavy snow collected
leaves or strong drafts.
Important:
In areas of heavy snow falls,
ground surface
clearance must
be increased
according to
average snow
falls.
21
Important:
In open area
with strong
wind, a wind
break may be
necessary.
5.
Do not install the flue
pipe down from the
heater nor into chimney.
6.
Total length of extension pipe between heater and flue pipe must be no
greater than 10 ft. and 3 bends may be used.
NOTE: When using extension pipes always cover the exhaust pipe with the
insulating cloth cover.