Download Installation Manual
Transcript
Wet/Dry Behavior It is important to note that in Master-Slave scenarios, the NETBXXPIV unit on the pivot will by default always relay pump start/stop messages to a NETB13PPAC if the pump panel is ON. To run the pivot dry, do one of the following: Turn the HAND/OFF/AUTO switch to the HAND position. Disconnect the power to the pump control panel. Use the NetIrrigate® mobile apps to simply disable the notification recipients associated with the remote pump control signals before starting the pivot. NETB13PPAC (Rev B) Copyright 2013 © Net Irrigate, LLC Page 7 of 15