Download Installation Manual

Transcript
Wet/Dry Behavior
It is important to note that in Master-Slave scenarios, the NETBXXPIV unit on the pivot will by
default always relay pump start/stop messages to a NETB13PPAC if the pump panel is ON. To
run the pivot dry, do one of the following:



Turn the HAND/OFF/AUTO switch to the HAND position.
Disconnect the power to the pump control panel.
Use the NetIrrigate® mobile apps to simply disable the notification recipients associated
with the remote pump control signals before starting the pivot.
NETB13PPAC (Rev B)
Copyright 2013 © Net Irrigate, LLC
Page 7 of 15