Download DevKit1207 Evaluation Kit User Manual

to EEPROM_WriteAddress2, which represents the address just after the last
written one in the first write.

After completion of the second write operation, the written data are read. The
contents of the written and the read buffers are compared.
All transfers are managed in DMA mode (except when 1-byte read/write operation is
required). Once sEE_ReadBuffer() or sEE_WriteBuffer() function is called, the user
application may perform other tasks in parallel while Read/Write operation is
managed by DMA.
This example provides the option to use the DevKit1207 LCD screen for messages
display (transfer status: Ongoing, PASSED, FAILED).To enable this option, user
need to uncomment the define ENABLE_LCD_MSG_DISPLAY in the main.c file.
4.18.2 GSensor-LIS33DE
1)
Purpose
This example shows how to configure the MEMS accelerometer to detect
acceleration on X/Y/Z axes.
Note:

Make sure that jumpers JP7 and JP8 are fitted.

Connect a null-modem female/female RS232 cable between the DB9
connector COM1 (USART3) and PC serial port if you want to display data
on the Hyper Terminal.

Hyperterminal configuration:Word Length = 8 Bits, One Stop Bit, No parity,
BaudRate= 115200 baud,flow control: None
2)
Description
After startup, the program checks for the G-Sensor (MEMS accelerometer) status
registers and behaves as follows:

If the board is moved as shown below, the acceleration is detected on the X/Y/Z
axis.
Page 87 of 155