Download REFERENCE BOOK FOR:

12. MAINTENANCE
The Arex system is very maintenance friendly.
Nevertheless, it is important to closely follow the instructions below.
12.1. Maintenance of the computer and accessories
Before carrying out any maintenance to the Arex system make sure the computer
and/or accessories are disconnected from the main electrical supply.
When necessary, the computer housing and glass fascia panel can be cleaned with
a soft, clean cloth dampened with a mild detergent, dissolved in water.
Do not allow water to penetrate into the computer housing.
The printer and alphanumeric keyboard can be cleaned using a dry, clean and soft
cloth.
When you need to change the printer cartridges, we would refer you to the separate
manual delivered with the printer. Printer cartridges can be ordered from your Arex
supplier.
Any other maintenance should only be carried out by a trained Arex engineer.
12.2. Maintenance to the floor items
The floor plates can be cleaned by an occasional brushing with a broom.
It is strongly recommended not to use air or water underneath the plates. This could
damage the bearings.
Avoid using aggressive detergents. This can also damage the bearings and even the
force transducers.
Never try to lift or move the plate without the supervision of a trained Arex engineer.
12.3. Periodic Maintenance
For periodic maintenance, calibration and service contact your Arex
supplier/installer.
When you want to report a problem for repair, supply a printout of the RAW data of
the system. This can be made by key 9 from the main menu and key 1 from the
maintenance menu. Use key 7 to print the data.
REFERENCE BOOK FOR AREX MODULAR WINDOWS GC SYSTEMS