Download USER`S MANUAL

Trademark Information
Brand or product names are trademarks or registered trademarks of their respective owners.
Intel® and Core-i7® are registered trademarks of Intel Corporation.
Windows® and Windows 7® are registered trademarks of Microsoft Corporation in the US and in other countries.
Copyright Information
This document is copyrighted by Xembedded, LLC (Xembedded) and shall not be reproduced or copied without
expressed written authorization from Xembedded.
The information contained within this document is subject to change without notice. Xembedded does not guarantee
the accuracy of the information.
WARNING
This is a Class A product. In a domestic environment this product may cause radio interference, in which case the
user may be required to take adequate measures.
Warning for European Users – Electromagnetic Compatibility
European Union Directive 89/336/EEC requires that this apparatus comply with relevant ITE EMC standards. EMC
compliance demands that this apparatus is installed within a VME enclosure designed to contain electromagnetic
radiation and which will provide protection for the apparatus with regard to electromagnetic immunity. This enclosure
must be fully shielded. An example of such an enclosure is a Schroff® 7U EMC-RFI VME System chassis, which
includes a front cover to complete the enclosure.
The connection of non-shielded equipment interface cables to this equipment will invalidate European Free Trade
Area (EFTA) EMC compliance and may result in electromagnetic interference and/or susceptibility levels that are in
violation of regulations which apply to the legal operation of this device. It is the responsibility of the system integrator
and/or user to apply the following directions, as well as those in the user manual, which relate to installation and
configuration:
All interface cables should be shielded, both inside and outside of the VME enclosure. Braid/foil type shields are
recommended for serial, parallel and SCSI interface cables. Where as external mouse cables are not generally
shielded, an internal mouse interface cable must either be shielded or looped (1 turn) through a ferrite bead at the
enclosure point of exit (bulkhead connector). External cable connectors must be metal with metal back-shells and
provide 360-degree protection about the interface wires. The cable shield must be terminated directly to the metal
connector shell; shield ground drain wires alone are not adequate. VME panel mount connectors that provide
interface to external cables (e.g., RS232, USB, keyboard, mouse, etc.) must have metal housings and provide direct
connection to the metal VME chassis. Connector ground drain wires are not adequate.
Environmental Protection Statement
This product has been manufactured to satisfy environmental protection requirements where possible. Many of the
components used (structural parts, printed circuit boards, connectors, batteries, etc.) are capable of being recycled.
Final disposition of this product after its service life must be accomplished in accordance with applicable country,
state, or local laws or regulations.
ii