Download Manual - Festo

Transcript
1.6.2 CoDeSys Support for FED-UIM
In order to use FED-UIM hardware with the FED-CEC Internal Controllers, the
proper I/O boards must be selected in the PLC Configuration.
Support for FED-UIM consists of a set of I/O boards as shown in Figure 53. To
insert the I/O board in the configuration, just “Replace” the “NoIO” slot with FEDUIM element.
Figure 53
1.6.3 Configuration of Analog Inputs
The FED-UIM Analog Input board has several parameters that have to be properly
configured according to the operation mode requested for each channel.
For all the four channels it is required to specify the operating mode and the fullscale limit.
Each channel can be used for:
1 Voltage differential measure, or
2 Voltage single-ended measures, or
1 resistance measure, or
1 current measure
Figure 54 shows the configuration of the four Analog Inputs Couples:
FED-CEC FED-UIM Description
50