Download Manual - Festo
Transcript
1.2 Getting Started The following chapter describes the basic steps to follow in order to get HMIcontrol running on the FED-CEC control modules. 1.2.1 Installing the FED-CEC Control Module The FED-CEC Control Module must be installed in the socket available for the optional Communication Modules. The Control Module must be installed with the panel powered off. Once the power supply is connected again the FED firmware will recognize the new module. Follow this procedure to install the module in the operator panel: 1 Turn off the operator panel. 2 Remove the rear cover. 3 Plug the module in the slot with red connectors and make sure the connectors are properly latched. 4 Re-install the rear cover. 5 Mount back the rear cover. 6 Stick in the area “B” the label indicating the type of module that has just been plugged in. Figure 4 1.2.2 Control Module Diagnostic The System Menu of FED provides some basic diagnostic information on the operation of the communication and control modules. To view the diagnostic information: 1 Make sure the operator panel is in Operation Mode 2 Recall the System Menu 3 Scroll down the display to show the bottom row of the page 4 The diagnostic information will be shown as in the example below: FED-CEC FED-UIM Description 6