Download Manual - Festo

Transcript
1.2
Getting Started
The following chapter describes the basic steps to follow in order to get
HMIcontrol running on the FED-CEC control modules.
1.2.1 Installing the FED-CEC Control Module
The FED-CEC Control Module must be installed in the socket available for the
optional Communication Modules.
The Control Module must be installed with the panel powered off. Once the power
supply is connected again the FED firmware will recognize the new module.
Follow this procedure to install the module in the operator panel:
1 Turn off the operator panel.
2 Remove the rear cover.
3 Plug the module in the slot with red connectors and make sure the
connectors are properly latched.
4 Re-install the rear cover.
5 Mount back the rear cover.
6 Stick in the area “B” the label indicating the type of module that has just
been plugged in.
Figure 4
1.2.2 Control Module Diagnostic
The System Menu of FED provides some basic diagnostic information on the
operation of the communication and control modules.
To view the diagnostic information:
1 Make sure the operator panel is in Operation Mode
2 Recall the System Menu
3 Scroll down the display to show the bottom row of the page
4 The diagnostic information will be shown as in the example below:
FED-CEC FED-UIM Description
6