1
Download Chapter 4 - Connectors
Transcript
Removing the Old System Board 1 .Observe the precautions in “Before You Begin.” 2 .Disconnect cables, connectors, etc. from the back panel. 3 .Remove any add-in boards. (If necessary, refer to Removing an Add-in Board, later in this chapter, for more information.) 4 .Remove the front 3.5-inch drive carrier, if necessary. 5 .Label and disconnect the all cables connected to the system board. 6 .Remove any metal screws that secure the system board to the chassis (Figure 2-1). Carefully lift the board up and out of the system. OM03940 page 7
