Download User`s Manual - Atel Electronics

Transcript
The User’s Manual for GEA-8120A
4.5.2 Mode
Choose the test layer and test mode. As shown in Figure 4.5.2:
Figure4.5.2 RFC2544Parameter setting mode selection
1. [Test Layer]: set the test layer. Choose Phy Layer, MAC Layer, or IP Layer.
2. [Test Mode]: Choose Remote Cooperation or Remote Loopback.
a) [Remote Cooperation]: the near tester is control end, the remote tester is
controlled end (working in “Cooperation”). The near tester connect and
control the remote tester by the IP address and name of remote tester.
b) [Remote Loopback]: the near tester send data. The remote tester or
equipment loopback the data frame to the near tester.
www.lzdd.com
26