Download 5. Loading the Media

15.4 Appendix D : Cutter Installation
1.
2.
1.
2.
Remove the E- ring(I), gear(27) and release the screw(F).
Remove the bracket-peeler(71) from the module.
3.
4.
5.
Secure two attached screws (B) for the cable connector.
Add a baby board to JP29 on the main board.
Plug the cable connector into JP13, and make sure Jumper
(J1) position is “2-3”
Click back the middle cover.
Click back the top cover.
Secure two attached screws (M) for the cutter.
Plug cutter cable into “ External Connector”.
Turn off the power switch.
Remove the top cover and middle cover.
Top Cover
H Cover
Middle Cover
Pull
Chassis 2
6.
7.
8.
9.
External Connector
Screw
Cutter Cable
69
70
www.meteorbarcode.it - [email protected]