Download User Manual

Transcript
V1.1
Cleaning with a Brush
Step 1
Use warm water or wash solution.
Step 2
Remove the flexible packing from the drive shaft.
Step 3
Remove the following components from the dasher assembly.
• Gasket
• Front bearing
• Handle
• Design cap
• Piston
Remove O-rings.
Caution: When removing an O-ring, take it out by grasping it with a new towel. Apply upward
force until the O-ring bounces out of the groove. Push its upper part down with the other hand.
The O-ring will then come out of the groove for easy removal. When removing more than one Oring, always remove the rear one first. By doing so, you can make each rear O-ring to come out
by sliding over the O-rings ahead of them without falling into otherwise empty grooves.
Step 4
Remove O-rings from the air carburetor and the air orifice.
Step 5
Inject a very small amount of wash solution into the freezing cylinder. Clean the rear bearing of
the freezing cylinder by scrubbing it with a cleaning brush.
Step 6
Remove the water trap and clean it.
Caution: If there is too much mix in the water trap, empty it first before cleaning.
Step 7
Clean all the disassembled components thoroughly with wash solution and make sure that
grease and mix have been completely removed. Pay special attention when cleaning the dasher
assembly. Lay all the cleaned components on a clean place and wipe them with dry cloth or wait
until they are fully dry.
Step 8
Clean all external surfaces of the machine thoroughly.
19