Download m2000 user manual

m2000 user manual
Preliminary
85 Edit exiting ticket
If you want to make changes to an existing ticket press 85 followed by the print select
key. You will be prompt with the message “TIC”. Enter the ticket you want to edit. If the
ticket exits the display will go into ticket edit mode.
86 Number of tickets
Press 86 followed by the print select key will display the number of tickets in the buffer.
87 Display Memory
This function displays how much of the ticket memory has been used for tickets. The
M2000 has 2Kbytes for tickets.
88 Clear Ticket Memory
This parameter totally wipes the ticket memory. All ticket data will be lost.
89 Delete Ticket
To delete a ticket press 89 followed by the print select key. The display will prompt you
with “TIC”. Enter the ticket that you want to delete followed by the print select key.
91 Assign PRINT/SELECT key
This parameter allows you to select which ticket will be the default ticket when the
indicator powers up. So when Print is pressed for the first time the ticket number that is
set in this parameter will be used to print the ticket.
92 Assign IN key
The IN key on the keypad can be assigned a ticket number. Normally this intended for a
ticket for a truck in sequence.
93 Assign OUT key
The OUT key is the same as the IN key and can be assigned a ticket number. This key is
normally used for truck out sequence.
95 Assign Barcode Scanner key
If you are using a barcode scanner with the M2000 you have the option of printing a
ticket when a scanner scans a barcode. Assign the ticket number you want to print or
enter 0 to disable printing.
Page 26