Download m2000 user manual

m2000 user manual
Preliminary
The last 3 digits is the data display field. Whatever value is displayed here represent your
ASCII character. If there is a ‘C’ or ‘P’ character displayed in front of the data field then
the value shown here is a control code and not a printable ASCII character.
Keys used by the ticket editor
Entering into ticket editor mode is done using Parameter 84 or 85.
The following keys are used to edit a ticket:
Move to the left in the ticket string.
Pressing the ON/OFF key scrolls the display one character to the left. If the
address display shows 00 then you are at the beginning of the ticket.
Move to the right in the ticket string.
Pressing the ZERO key scrolls the display once to the right. If you are at the
end of the ticket, then “END” will be displayed.
This key is used in conjunction with the above two keys. Pressing the key
once followed by one of the above keys will jump to the next LF character.
Pressing the key twice will jump to the beginning or end of the ticket.
Functions as an ENTER key for entering data. All data entry must terminate
by the print select key.
This important key is used to toggle between normal ASCII entry mode and
Control Code mode. Pressing the decimal once will display the ‘C’ control
code. Pressing it again will display ‘P’ and pressing the decimal key for the
third time will return you back to ASCII entry mode. You may press the CLEAR key at
any time to abort command mode and return the display back to its previous state. After
you have pressed the decimal key you then enter the numeric value followed by the
PRINT/SELECT key. You have now entered a control code.
Page 28