Download m2000 user manual

Transcript
m2000 user manual
50
51
Preliminary
Turn Unit printing OFF
Whenever a weight is printed the units kg or lbs will follow the
weight depending on the units of weight being printed. This
functions turns unit printing off.
Turn Unit printing ON
Only required to be used if unit printing was turned off earlier. Unit
printing is on by default.
70
Truck IN loop
This function is used for truck in/truck out weighting.
Store weight by ID number to memory when a truck enters the
facility.
This function prompts the user to enter an ID number from the
keypad. The ID is checked and an error is given if there are
duplicate ID numbers. When a duplicate ID number is found the
ticket aborts. The weight in stored together with the entered ID
number and time and date. Use parameter 71 below to retrieve the
stored weight.
71
Truck OUT loop
Recall weight by ID from memory when a truck leaves the facility.
This function searches the memory for a truck by it ID number
entered using parameter 70 above.
This function prompts the user to enter an ID number. It then
searches the memory for a matching ID. When an ID match is
found the weight is retrieved.
If the ID number cannot be found in memory then an error is given
and the ticket aborts. After the weight is retrieved the ID number is
deleted and its weight is deleted from memory.
After the weight has been retrieved from memory the function
compares the retrieved inbound weight with the outbound weight
currently on the scale.
If the inbound weight is less than the outbound weight it becomes
the tare weight and the outbound weight becomes the gross weight.
If the inbound weight is greater than the outbound weight it
becomes the gross weight and the outbound becomes the tare
weight.
Page 32