Download electronic cuber model ec 106
Transcript
Page 33 Page 33 ADJUSTMENT PROCEDURES A. ADJUSTMENT OF THE CUBE SIZE CAUTION. Before performing actual adjustment of the cube size , check other possible causes for cube size problems, refer to the Service Diagnosis Section for problem review and analysis. Do not perform any adjustment till the icemaking system has progressed through several complete freezing and harvest cycle, to observe size and quality of ice cubes and whether or not the cube size problem exists. SMALL IDENTATION I. If the cubes are shallow size (Indentation is too deep) probably the length of the second phase of the freezing cycle is too short so, to extend such length you have to: 1. Locate the DIP SWITCH on the front of the P.C.Board. 2. Take note of the combination of the first four DIP SWITCH KEYS and check the corrisponding length of freezing cycle 2nd phase on Table B. 3. Set the same DIP SWITCH KEYS to correspond to the prior combination shown on Table B which allow an extention of two more minutes of the length of the freezing cycle. LITTLE OR NO ICE IN CENTER OF CUBES 4. Observe the ice cubes in the next two harvests and eventually repeat steps 2 and 3 above until proper ice cubes size is achieved. See figure. II. If the cubes are oversize size (Indentation is too full) probably the length of the second phase of the freezing cycle is too long. To shorten such length you have to: 1. Locate the DIP SWITCH on the front of the P.C.Board. 2. Take note of the combination of the first four DIP SWITCH KEYS and check the corrisponding length of freezing cycle 2nd phase on Table B. 3. Set the same DIP SWITCH KEYS to correspond to the next combination shown on Table B which allow a reduction of two minutes of the length of the freezing cycle. 4. Observe the ice cubes in the next two harvests and eventually repeat steps 2 and 3 above until proper ice cubes size is achieved. See figure. THICK BULGE SOLID ICE