Download Revision

How to Perform Advanced Tuning Techniques
Stabilization filters
Stabilization filters are available for control modes equipped with stabilization
resources and include:
•
A 1 Hz High-pass filter that attenuates signals below 1 Hz.
•
A Band-pass filter that attenuates signals outside of a user-definable band.
To select a Stabilization filter, select and set up the desired filter type of 1 Hz
High-pass or Band-pass.
–
Note
120
Tuning Procedures
For Band-pass filters, set the frequency band with the Frequency
Limits control.
Some systems with a higher actuator frequency may benefit by selecting
the following Frequency Limits: a low cut-off frequency that is
approximately the actuator frequency and a high cut-off frequency
approximately 5-10 times the actuator frequency.
MTS Series 793 Tuning and Calibration