Download Installation Instruction

PARTS LIST FOR #013004,
013005, 013006
Part#
Qty Description
963181012Q4
963181100H4
N96FH
W96S
083401R
8
8
1
083403R 1
01067-11
01057-11
BP1234011
4031
01019
2
01027-1 2
01067-11
01057-11
M02016RB 4
65-1
4
9/16 x 3-1/8 x 10-1/2" Square U-bolt
(013004, 013005 only)
or
9/16 x 3-1/8 x 11" Radius U-bolt (013006
only)
9/16" High Nut
9/16" SAE Flat Washers
Pitman Arm (013004 only)
or
Pitman Arm (013005, 013006 only)
Track Bracket (013004 only)
or
Track Bracket (013005, 013006 only)
Bolt Pack
Bolt Pack
4" Link Kit
Bump Stop Drop
Track Bracket (013004 only)
or
Track Bracket (013005, 013006 only)
Large Shock Eye
3/4 x .134" x 1.650" Dom Sleeve
FIG. 1
4. Remove the anti-sway bar end links (Fig 2). Remove
the cotter pin and castle nut from the drag link at the
pitman arm. Use a tie rod puller to separate the tie rod
end from the pitman arm.
PARTS LIST FOR #013007 & 013009
Part#
Qty Description
583581500R4
583581200R4
N58FH
8
W58S
8
B381G21
SBLA
1
B382G51
LW38
2
45313-11
4KB-W96 2
5/8 x 3-5/8 x 15" Round U-bolt (013007)
or
5/8 x 3-5/8 x 12" Round U-bolt (013009)
5/8" High Nut
5/8" SAE Flat Washers
3/8 x 1" Bolt
Brake Adapters
3/8 x 2" Bolt
3/8" Lock Washer
5/8 x .109 x 1.375" Sleeve
4" Lift Block (013007 only)
FIG. 2
5. Remove the three bolts that retain the factory track
bar bracket to the frame. Set the bracket off to the
side and retain the factory fasteners for later use.
(Fig 3)
Installation INSTRUCTIONS
Helpful Hint: The following installation may go easier if
you remove the front bumper before you begin. The bumper is attached by four bolts. The removal will require two
people. This is not necessary for installation, but will make
removal of the front spring eye bolts easier.
1. Unhook the track bar at the top end where it attaches
to the frame bracket. Retain fasteners for later use.
2. Raise the front of the vehicle and support with jack
stands. Be sure to chock the rear tires. Remove the
wheel and OE shock.
3. With a large set of pliers, bend the OE brake line
mounting tab on the frame out to 45 degrees. Remove
the bracket from the frame and retain the OE fastener.
(Fig 1)
Page of 4
FIG. 3
6. Remove the nut and washer from the steering shaft
that retain the pitman arm. Remove the pitman arm
using a pitman arm puller.
Complete the following instructions one side at a time.