Download LOCKWELT 3000

Transcript
LOCKWELT 3000
TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE
Turning the main electrical
power rotary switch off,
turning the main electrical
power on and releasing the
Program Stop push-button will
Reset the machine and
sometimes clear an Error
message. It is recommended
before troubleshooting
procedures are performed.
Error message displayed
Error - 01 = Sewing program
empty
Distances and values are not
entered, or the program was
deleted.
Error - 02 = Pocket style
deactivated
Pocket style number is not
highlighted.
Error - 05 = I/O communication Transfer error between controls
and the I/O module.
error
Faulty controls.
Faulty I/O module.
Error - 06 = Invalid path pulses
If the clamp motor performs a
small movement, the path
pulses won´t process correctly.
Motor fault.
Faulty activation or power part
of the clamp motor.
2-4
Manually enter the program
values or copy from other
programs or load from
memory.
Initial parameters.
Press the ENT key to activate
and highlight the pocket style.
Check the wire connections.
Replace the controls.
Replace the I/O module.
Incorrect clamp sledge position.
Faulty adaptation module
9020020
Error - 07 = No path pulses
from the clamp motor
POSSIBLE SOLUTION
Check the generator
connection to the clamp motor.
Check the adaptation module
flat conductor plug 9020020
and 9020013.
Replace the adaptation module
9020020.
Check the clamp motor
connection.
Replace the clamp motor.
Replace the adaptation module
9020020.
Check the power card diodes.
Perform motor diagnostic
check of connection 9020020.
Replace the adaptation module
9020020. Released January 2001
U.S. Phone 800-237-3323
Outside U.S. Phone 1-804-559-5000 Fax 1-804-559-5210