Download TE27 / TE32

Maintenance
Perform the following steps in order to heat up the transmission :
1. Make sure the parking brake is active and works properly.
2. Put the transmission in forward by selecting forward with the shift lever and then accelerates the engine to full throttle.
3. Keep the engine at full throttle for about 15 seconds and then put the gearbox in neutral by selecting neutral with the shift lever. Keep the engine at full throttle!
4. Keep the gearbox in neutral at full engine throttle for about 15 seconds again.
5. Release the throttle pedal and decelerate the engine to idle.
6. Go back to point 2 and repeat until the APC200 display shows a temperature above 60°C. When the
temperature is above 60° C, the temperature indication on the display starts blinking. Now you can switch to the automatic calibration, by pressing the M-button for several times – until the APC200 displays “tran”.
FULL
IDLE
forward
neutral
15 Sec.
15 Sec.
REMARK :
During this warm up procedure, it is possible that the converter out temperature of the transmission exceeds the
maximum limit. This is a consequence of heating up the transmission using this quick procedure.
When this occurs, the engine speed will be limiting to half throttle when the APC200 has engine control or forcing
neutral when the APC200 has no engine control. To solve this, simply leave the transmission in neutral for a
minute and throttle the engine to around 1300 rpm. This will allow the heat in the converter to be evacuated.
After one or two minutes, you can resume the heating up procedure if the transmission temperature has not
reached 60 °C yet.
T27/32 4 SD
03/2010
4-24