Download TE27 / TE32
Transcript
assembly instructions All lead-in chamfers for oil seals, pistonrings and 0-rings must be smooth and free from burrs. Inspect at assembly. Add some grease to 0-rings before assembly. Add some grease to piston rings before assembly. Apply a thin coating of grease between seal lips on lip type seals prior to assembly. Use only precoated pipe plugs. On uncoated pipe plugs apply a light coat of Loctite© 592 Pump must be filled up with oil prior to assembly. After assembly of parts using Loctite© there must not be any free or excess material which might enter the oil circuit. 1 Apply a light coat of Loctite© 262 or 270 to all thru hole stud holes. 2 Teflon seals must be sized prior to assembly. Add some grease to seal diameter of clutch hub before assembly. 3 Fwd and Rev Clutch TE32 11 seperator plates with outer splines. 11 friction plates (friction material on both sides) with inner splines Clearance TE27 Min Max 6.0mm [0.23in] 6.4mm [0.25in] 8 seperator plates with outer splines. 8 friction plates (friction material on both sides) with inner splines. Clearance Min 6.0mm [0.23in] Max 6.4mm [0.25in] Choose an end plate with suitable thickness to obtain this clearance. Caution The seperator plates for Fwd and Rev and 1st and 2nd are not the same. DO NOT MIX PLATES WITH PLATES FROM OTHER CLUTCHES. 4 1st Clutch TE32 11 seperator plates with outer splines. 11 friction plates (friction material on both sides) with inner splines Clearance TE27 Min Max 4.35mm [0.17in] 4.75mm [0.19in] 10 seperator plates with outer splines. 10 friction plates (friction material on both sides) with inner splines. Clearance Min 4.35mm [0.17in] Max 4.75mm [0.19in] Choose an end plate with suitable thickness to obtain this clearance. TE27/32 4 SD 03/2010 9-111