Download ML320/ML321 Dot Matrix Printers
Transcript
+ 5 vdc Take the voltage reading between Pin 16 and Pin 34 of the IC4 (ROM) on the control board. + 50 vdc Take the voltage reading between both leads of C33 on the control board. Meter should read + 50 vdc. YES Go to D NO Is the power cable correctly connected to CN4 of the control board? YES Replace the transformer. Is the problem resolved? NO YES End of procedure. NO Go to D. Correctly connect the cable. Is the problem resolved? YES End of procedure. NO Go to D. D Is the carriage cable properly inserted into CN2 of the control board? NO Properly insert the cable. Is the problem resolved? YES YES End of procedure. NO Go to the next step listed below. Replace the control board. Is the problem resolved? YES End of procedure. NO Replace the space motor. Is the problem resolved? YES End of procedure. NO Contact Technical Support. Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business