Download ML320/ML321 Dot Matrix Printers

Transcript
+ 5 vdc
Take the voltage reading between Pin 16 and Pin 34 of the IC4 (ROM) on the
control board.
+ 50 vdc
Take the voltage reading between both leads of C33 on the control board. Meter should
read + 50 vdc.
YES
Go to D
NO
Is the power cable correctly connected to CN4 of the control board?
YES
Replace the transformer.
Is the problem resolved?
NO
YES
End of procedure.
NO
Go to D.
Correctly connect the cable.
Is the problem resolved?
YES
End of procedure.
NO
Go to D.
D
Is the carriage cable properly inserted into CN2 of the control board?
NO
Properly insert the cable.
Is the problem resolved?
YES
YES
End of procedure.
NO
Go to the next step listed below.
Replace the control board.
Is the problem resolved?
YES
End of procedure.
NO
Replace the space motor.
Is the problem resolved?
YES
End of procedure.
NO
Contact Technical Support.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business