Download R&S SMF100A Operating Manual

R&S®SMF100A
Instrument Function
General Instrument Settings
Time
Indicates the time in the format hour.minute.second
In order to prevent accidental changes, this parameter is protected. It can be accessed
with protection level 1, see ​chapter 5.2.3.15, "Protection", on page 109.
SCPI command:
​:​SYSTem:​TIME​ on page 544
5.2.3.11
Network Settings
The "Network Settings" dialog provides access to the network settings. To access this
dialog, press the SETUP or MENU key under "Environment". The R&S SMF is equipped
with a network interface and can be connected to an Ethernet LAN (local area network).
How to connect the signal generator to the network is described in ​chapter 2.6.1, "Connecting the Instrument to the Network", on page 35.
Risk of network errors!
Connecting errors may affect the entire network.
We recommend to coordinate the connection of the instrument to the network with the
network administrator.
Do not connect or disconnect the network cable until the instrument is switched off
(standby). Only then the network connection can be reliably detected and impairments
to instrument operation can be avoided.
The dialog provides an access to the network settings, like settings about the general
network environment and specific identification of the computer in the network, as well
as an indication whether the instrument is connected to the network or not.
Network Status
Indicates whether the instrument is connected to the network or not.
SCPI command:
n.a.
Operating Manual 1167.2319.32 ─ 08
102