Download Owner`s Manual

7167 Owner’s Manual
Appendix A: Specifications
Reliability
The numbers in the table refer to the Mean Cycle Between Failure (MCBF) for the items
indicated.
Thermal Receipt Printer
45 Million Lines
Impact Slip Printer
15 Million Lines
Impact Print head
200 Million Characters
Electronics
347,000 On time Hours
Communications Card
2,000,000 On Time Hours
Control Panel
2,100,000 On Time Hours
Knife
1 Million Cuts
MICR Check Reader
200,000 Reads
Flip
200,000 Flips
Power Supply
200,000 On-time Hours
Flip Mechanism
200,000 Cycles
Dimensions and Weight
Height
174 mm (6.9 Inches)
Height with Cover Open
296 mm (11.7 Inches)
Width
190 mm (7.5 Inches)
Depth
262 mm (10.3 Inches)
Depth with Extended Slip Table
316 mm (12.5 Inches)
Weight
4.50 Kg (10.0 Pounds), Flip Model
4.25 Kg (9.4 Pounds), Non-Flip
Model
Density of Receipt Print Lines
When the receipt station prints high density print lines (graphics), it automatically slows
down to a rate slower than 902 lines per minute. High density print lines are defined as
lines with over 50% of the dots printing on the line (there are 576 total dot columns on the
print station).
Duty Cycle Restrictions (Printing Solid Blocks)
There are restrictions on the duty cycle because of the heat generated by the receipt
thermal print head when printing solid blocks (regardless of the length of the block in
relation to the print line). The restrictions are ambient temperature, the percentage of time
(measured against one minute) of continuous solid printing, and the amount of coverage.
Caution: When the duty cycle approches the limits shown in the table, the receipt print
head will heat up and shut down. This may damage the print head.
November 2002
215