Download Micro-Tech 3106 Impact Flowmeter Integrator Operations & Service

Transcript
Micro-Tech 3106
After START is pressed, the following screens are displayed in sequence.
- TEST SCROLL 2A Testing ROM
TEST PASSED
- TEST SCROLL 2B Testing ROM
TEST PASSED
The message "Test PASSED" is displayed if the test runs correctly. If something
wrong is detected, then the message "Test FAILED" is displayed, and the soft
key CONTINUE is shown. The operator has to press CONTINUE to go on the
next test.
NOTE: Test 2C requires a hardware jumper to be installed between serial in
and serial out pins of the motherboard. Since the jumper is not normally in
place, a "Test FAILED" message at the end of Test 2C is normally displayed.
3. Test Digital Inputs
The next screen is used to check the digital input circuitry. The display shows a
1 if the specific input is closed, 0 if open. If more digital I/O boards are
installed, the NEXT soft key displays, allowing the operator to scroll between
boards.
Scroll DOWN and the digital input test screen displays.
- TEST SCROLL 3 Dig input test
Slot #0: - - - - 0000
NEXT
Slots are numbered 1 to 6; slot 0 is the motherboard. Inputs are shown from right
to left. If a board has 16 inputs, two screens are used to show the first and the
second half, the lower half is shown first.
4. Test Digital Outputs
This test shows the status of each digital output and allows the operator to force
the output for testing purposes. The output, when forced, stays on until the
CLEAR soft key is pressed or the Run Menu is entered. If an output is forced
and the scroll key is used for reaching some other menu, the output stays in the
forced status until RUN is pressed. This allows the operator to check inputs
while outputs are still in the forced status.
B-20
REC 4187