Download D067/D068/D069/D072 Service Manual Appendix

System Service Mode (Basic: D067/D072)
2927*
2927 1
2928
ID Sensor Control
[0 = No / 1 = Yes]
Determines whether the ID sensor signal is referenced or not for the toner
density control. Keep the default value in usual operations.
Toner End Clear
Clears the following messages and counters without supplying the toner:
2928 1
Toner near end message
Toner end message
Toner near end counter
Toner end counter
Do not use this SP in usual operations. When the toner in the development
unit is abnormally insufficient, the drum may attract the toner carrier to its
surface. The toner carrier damages the drum surface..
Vref Limits
Adjust the upper or lower Vref limit.
2929 1 Upper
[0.50 to 3.50 / 3.20 / 0.01V/step] DFU
2929 2 Lower
[0.50 to 3.50 / 0.70 / 0.01V/step] DFU
2994*
ID Detect Temp
[30 to 90 / 30 / 1 °C/step]
Adjusts the temperature threshold. The ID sensor signal is not referenced
2994 1 when the fusing temperature is at the specified level or higher while the
copier is recovering or starting up.
SM Appendix
5-151
D067/D068/D069/D072
Appendix:
SP Mode
Tables
2929*