Download install/removal instructions: window regulator
Transcript
741-585 INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully. STEP 8: With the slider aligned with the door frame hole, you should see a circular plastic retainer with another smaller retainer inside of it. This setup goes through the holes in the Window Regulator slider as well as the hole in the window glass to secure the glass to the slider. The smaller pin pushes into the larger retainer and spreads it apart to make a tight fit against the slider and the glass. For reference, look at the replacement Window Regulator to visualize the slider to glass fitment. In order to separate the window glass from the Window Regulator slider, you need to push the center pin out of the larger retainer and then push the larger retainer out of the slider and window glass. Using a small hammer and a punch, tap the small pin out first and then tap the larger pin out. These will fall into the door frame. Retrieve these pieces as you will need them to reattach the replacement Window Regulator. The Window Regulator should now be free from the window glass. Line slide holes up with oval door frame hole Outer and inner retainer pieces – use punch to tap out STEP 9: Use the window switch or manually move the window glass into the full upright position. Secure the window glass to the door frame using tape. Painter’s tape works well because it will not damage the door paint or leave a sticky residue. Disclaimer: Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature. ©2011 Dorman Products, Inc. No reproductions in whole or in part without prior written approval. 7