Download 4 - Infiniti

Transcript
VEHICLE ALARM IMPACT SENSOR
Fig. 6
b)
a)
3) Tap vehicle wire. Fig. 6
a) Remove cap (slot side) from tap body.
b) Slide cap around vehicle wire.
c) Tighten the tap TIGHT with finger pressure.
Note:
Do not re-use the tap for subsequent re-installation.
c)
Fig. 7
4) Inspect the tap to ensure correct installation. Fig. 7
Note:
Avoid putting pressure on the vehicle wire and
tap for the rest of the installation.
i. Straight and evenly spaced all the way around.
ii. Tight and minimize gap (wire jacket should be
crushed).
Fig. 8
5) Tap the Red wire from the Impact Sensor Harness.
Fig. 8
a) Remove tap (non-pierce) side from tap.
b) Remove protective stub from Red wire.
c) Insert the Red wire through the non-pierce side
opening.
d) Spread the individual strands into a fan shape.
e) Insert wire into the tap body and ensure that it
is all the way in.
f) Tighten the tap TIGHT with finger pressure.
e)Insert wire to here
c)
a)
d)
f) Tighten
b) Protective Stub
Harness Wire
4280266
Page 5 of 8
999M2 JW001 REV 1/4/10