Download National Check Network Reference Guide

Transcript
Transactions initiated using other keys work exactly the same way using locations x00 x12, where “x” is any key in the range of 1 - 9. As transaction complexity increases, the
programs grow too large to fit in a single location, so instructions exist to transfer control
to other locations in general purpose memory that contain further program instructions.
Early terminals such as the ZON Jr PLUS have only very limited memory with a two digit
address and only permit programs started by keys 1 - 5. Later terminals, such as the
TRANZ 380 have much more memory with a four digit address. The basic concepts carry
though the entire line however, with increased memory and program capability in later
terminals.
Setting up a terminal for a download usually requires examination of the contents of
specific locations and storage of new data in these locations. The following paragraphs
explain these basic operations.
Verifone Terminal EPROM Versions
Table 10-1. Verifone EPROM Versions
Version
EPROM Version
Release Numbers
Details
Important things to be aware of concerning the Verifone terminals is the EPROM
version and release numbers. The EPROM version is displayed briefly when the
unit is powered on. Version and release numbers resemble the following:
ZON Jr XL-Jr XL XE2AU2.8
XL 300-XL 300 LE2AU1.25
TRANZ 330-TZ 330 3E2EU2.1
TRANZ 380-TZ 380 9E2EU1.23
Where the bold letters represent the version and the underlined
Table 10-2. Verifone EPROM Minimum Requirements
Verifone
Terminal Type
ZON Jr XL
EPROM Minimum Requirements
The Verifone ZON Jr XL in order to work with a checkreader, must be EPROM
release number 2.8 or higher.
When using a Printer and Checkreader, you must employ a “Y” cable
Password access to Functions 7 and 8 is [1] [6] [6] [8] [3] [1] [FUNC/ENTER].
XL 300
The Verifone XL 300, in order to work with a checkreader, must be EPROM release
number 1.25 or higher.
When using a Printer and Checkreader, you must employ a “Y” cable.
Password access to Functions 7 and 8 is [1] [6] [6] [8] [3] [1] [FUNC/ENTER].
10 - 4
NCN Training Guide