Download National Check Network Reference Guide
Transcript
Transactions initiated using other keys work exactly the same way using locations x00 x12, where “x” is any key in the range of 1 - 9. As transaction complexity increases, the programs grow too large to fit in a single location, so instructions exist to transfer control to other locations in general purpose memory that contain further program instructions. Early terminals such as the ZON Jr PLUS have only very limited memory with a two digit address and only permit programs started by keys 1 - 5. Later terminals, such as the TRANZ 380 have much more memory with a four digit address. The basic concepts carry though the entire line however, with increased memory and program capability in later terminals. Setting up a terminal for a download usually requires examination of the contents of specific locations and storage of new data in these locations. The following paragraphs explain these basic operations. Verifone Terminal EPROM Versions Table 10-1. Verifone EPROM Versions Version EPROM Version Release Numbers Details Important things to be aware of concerning the Verifone terminals is the EPROM version and release numbers. The EPROM version is displayed briefly when the unit is powered on. Version and release numbers resemble the following: ZON Jr XL-Jr XL XE2AU2.8 XL 300-XL 300 LE2AU1.25 TRANZ 330-TZ 330 3E2EU2.1 TRANZ 380-TZ 380 9E2EU1.23 Where the bold letters represent the version and the underlined Table 10-2. Verifone EPROM Minimum Requirements Verifone Terminal Type ZON Jr XL EPROM Minimum Requirements The Verifone ZON Jr XL in order to work with a checkreader, must be EPROM release number 2.8 or higher. When using a Printer and Checkreader, you must employ a “Y” cable Password access to Functions 7 and 8 is [1] [6] [6] [8] [3] [1] [FUNC/ENTER]. XL 300 The Verifone XL 300, in order to work with a checkreader, must be EPROM release number 1.25 or higher. When using a Printer and Checkreader, you must employ a “Y” cable. Password access to Functions 7 and 8 is [1] [6] [6] [8] [3] [1] [FUNC/ENTER]. 10 - 4 NCN Training Guide