Download Authority22 v.2.0 Lane Machine

 2. Oil levels
The oil levels screen allows you to create the shape and levels of the
conditioner pattern in units of oil. Minimum and maximum levels range
from 0 to 100 units. To create the proper lengthwise taper of a pattern, oil
levels, from zone to zone, should decrease between 15% and 30%. This
is the same for sport and recreational patterns. The percent decrease from
zone to zone depends on the starting oil level in the first zone. If the first
zone conditioner level is lower (60 units or less) the percentage decrease in
the following zones will be smaller and if the first zone conditioner level
is higher (above 60 units), the percentage of decrease is higher. The last
zone or buff zone should have 1 to 3 units set in the oil level screen on at
least one board. This allows the machine to buff the remaining zone of
the pattern, in both directions, without injecting conditioner and enhance
the lengthwise taper. Set all boards for zero (0) and the machine will buff
the last zone in the forward direction of travel only. This increases the
lengthwise taper even more. Refer to Figure 7-4.
Figure 7-4. Oil Levels
Section
7: Pattern &
Design
Theory
Authority22
v.2.0 Operation
Service
Manual
189