Download 3 - Jegs

29. Locate the coolant line bracket and electronic signal noise filter just below the coolant inlet on the
passenger side of the engine. Using a 15 mm socket remove the nut securing the coolant line bracket
and the electronic signal noise filter. SEE FIGURE 49
FIGURE 49
Nut
Bracket
Electronic Signal
Noise Filter
30. Reinstall the electronic signal noise filter on the stud below the coolant inlet on the passenger side of the
motor. Install with the Ford label facing away. Carefully bend the device away from the coolant inlet.
Secure with the factory nut. SEE FIGURE 50
FIGURE 50
31. The A/C lines need to be carefully bent into new positions as shown in the following pictures. Bend the
lines so that they run close to the radiator fan shroud and the passenger side frame. SEE FIGURE 51-54
60164revC
Page 21 of 75