Download Dealers guide to FleetSync Programming

FleetSync™ Radio Versions
Based on customer input Kenwood has made firmware and hardware design changes to the 80 series radios
to add new features and improve upon existing features. The new design is called 80 series Version 2.
These radios can be identified by the logos located on the radio front panel. The mobile units logo has been
changed from a white Kenwood logo to a Orange logo. The portables Kenwood logo’s triangle [above the
“W”] has been changed from white to orange. The Model/FCC ID label will read Ver- 2. The table below
shows the changes made in version 2 compared with version 1.
Version 1
N/A
Caller ID
( PTT ANI Decode )
Selective Call ID Stack
(Last 3 Calls)
Version 2
Standard
N/A
Standard
PTT ID Side Tone
PTT ID TA Inhibit
ID List Capacity
Status Message Capacity
ID / Status Access
N/A
N/A
32
32
Rotary
Encoder
Standard
Standard
100
50
C&D Keys
PTT ID Type
On / Off
Own/Sel
TX Inhibit Per ID / Status
BCL
N/A
On / Off
Standard
Off / QTDQT Tone /
Optional
Signaling
N/A
Special
Status 89
N/A
Special
Status 98
Emergency Mode
Disable
N/A
Special
Status 88
Emergency Locator
Tones
N/A
Before and
After
Emergency
1 For GPS
1 For
Messaging
Same as
Version 1
or 1 for
Both
FleetSync™ Horn Alert
Note 1
Emergency Man Down
Note 1
Com Port Configuration
Note 1 – Additional Equipment Required
11/01 Rev 2.0
4