Download Mark V Centrifugal Extractor Controller - Cost

DEFINITIONS OF TERMS AND
ABBREVIATIONS
Term
C
MSFDD412CE/9905CV (8 of 13)
Applies to
these machines
Definition
Flow-not
CBW® washer
valve to divert “bad” liquor to sewer instead of allowing normal
counterflow into the next water-receiving module.
Flow of Goods
all models
direction goods flow through a machine that accepts goods at
one end and discharges them out the opposite end.
Flow Splitter
CBW® washer
tunnel ancillary component that accepts bath liquor from the
rinse zone, removes lint, and pumps part of liquor to Reuse tank
and part to wash zone; permits higher level in wash zone.
Formula
all models
instructions used by the machine control to operate motors,
valves, and other components during a standard cycle.
Formula Code
CBW® washer;
Dryer
see Code, Formula
Full Dry
Dryer
dryer formula that removes virtually all moisture from the goods.
Gains, PID
Modulating Dryer;
DyExtractor®
proportional-integral-differential gains, a set of constants used by
the software in Milnor® dryers to determine the temperature and
its rate of change at the inlet and outlet temperature probes.
Goods
all models
articles processed or conveyed by a machine.
Hard Start
Dryer
process by which dryer basket motors momentarily provide additional torque to start into motion a loaded stationary basket.
Hardware
all models
electronic boards that control the machine.
Hold
CBW® washer
condition where count-up or transfer is suspended because prerequisites are not met; if caused by a loading error, flow is disabled
Home
Shuttle Conveyors
specific position along the shuttle path to which the shuttle returns upon power up; or after discharge, load, or error correction; belt is at receive level 0.
Inching
washer-extractor
a control mechanism with which an operator can manually align
one pocket of a divided cylinder machine with the loading doors.
Init Code
CBW® washer
see C-Bit Init Code
Input, Direct
all microprocessorcontrolled models
signals that enter the processor board directly; direct inputs are
provided by switches on the machine, including limit switches,
the Signal Cancel button, and the Run/Program keyswitch.
Input, Module
CBW® washer
signals that enter the Miltron processor board through the first I/O
board of each tunnel module; module inputs are provided by level
switches, module-specific circuit breakers and motor overloads,
etc.
14