Download Instruction Manual

REAR PANEL-INSTALLATION
CHIP CHANGER:
MONO.:
DET. A and B:
SOURCE:
Connects to chip changer.
Connects to the monochromator.
Connects to the light detector.
Connects to the light source.
I/O PORTS A and B: Each Digital I/O Port has 7 isolated selectable outputs and 4 isolated
selectable inputs. Each port can be easily configured to communicate with the XYC-20 and
any standard opto isolator.
TERMINAL PORT: This port allows you to communicate with the EDDYLog and
EDDYLink software installed on a PC compatible computer. This will allow complete
memory upload and download and complete data logging. This port may be connected to a
PC with a terminal port program, configured for 4800 baud.
PRINTER: Not enabled by our V 6.2 or higher software.
XTAL: This standard RS-232 port is configured for Sycon (set to 300 baud), Maxtek MDC360 (set to 9600 baud), Inficon IC5 (set to 9600 baud). This port is used to select the material and initiate and terminate the coating process at the appropriate optical thickness or
designated physical thickness.
XYC-20: Not enabled by our V 6.2 or higher software.
10