Download 3D - Rapid Electronics

Command Descriptions
RS232? (Query Only)
Returns the RS232 settings.
Group
RS-232
Syntax
RS232?
Returns
Examples
The current RS-232 settings.
RS232? might return the following string: RS232:BAUD 9600; SOFTFLAGGING
0; HARDFLAGGING 1; PARITY NONE; TRANSMIT:TERMINATOR LF
RS232:BAUd
Sets or queries the RS-232C interface transmission speed. If no flow control
(flagging) is used, commands may be received faster than the oscilloscope can
process them. Also, if another command is sent immediately after this command,
without waiting for the baud rate to be programmed, the first couple of characters
may be lost.
Conditions
This command applies to the TDS200, TDS1000, TDS2000, and TPS2000 Series
only.
Group
RS-232
Syntax
RS232:BAUd <NR1>
RS232:BAUd?
Arguments
Examples
<NR1> which can be 300, 600, 1200, 2400, 4800, 9600, or 19200.
RS232:BAUD 9600 sets the transmission rate to 9600 baud.
RS232:HARDFlagging
Sets or queries the state of RS232 hard flagging. When hard flagging is enabled,
the oscilloscope sends data if CTS (Clear To Send) is asserted. When receiving
data, the oscilloscope asserts RTS (Request To Send) until the input buffer is
almost full. When the oscilloscope no longer asserts RTS, it continues to read
2-140
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer