Download BASIS Wi-Q Interface User Guide - knowledge base

Figure 7 Wireless Access Controller.
Installation
Specific installation methods are dependent on the device type and
configuration of the system; therefore, the WAC should be installed
by a trained technician using the instructions provided with the
controller.
WARNING: Wireless Access Controllers are intended for use in
indoor or protected area. For other applications, such as outdoor
use, contact the factory for the appropriate NEMA enclosure.
Changes or modifications not expressly approved by Stanley
Security Solutions could void the user’s authority to operate the
equipment.
Wireless Access Control Wiring
The Wireless Access Controller (WAC) can be installed with its own
12 VDC power supply or slaved to the existing installation. Figure
8 is a wiring diagram illustrating both configurations. Dotted lines
represent optional connections for the slaved configuration.
25