Download section i - Sensible Tech

D.2c2 Paper Hopper Adjustment
The Guide Rails align the paper from the hopper table
into the singulator. This permits the paper to exit the
singulator area in proper alignment with the transfer
conveyor, without skew. The position of the hopper
table relative to the feeder is a very critical adjustment.
To adjust the hopper table:
a)
Place a sheet of paper in the feed area, up to
but not under the singulator.
b)
Loosen the four set screws of the hopper guide
rails. Once this is accomplished the table will
move freely in and out. Do not pull the table all
the way out of the clamps: it will fall!
c)
Bring the hopper table 1/2" away from the back
edge of the sheet of paper.
d)
Tighten four set screws down to clamp the table
into this position.
Whenever document length is changed this process
must be performed to ensure the proper transfer of
paper from the hopper table to the feeder area.
SMART FEEDER SERVICE MANUAL
ISSUE 09/00
REPAIR INFORMATION
SECTION D – PAGE 7