Download Tune It 2

Run PWM as an On/Off Switch
By selecting this option the PWM output is forced active (0V, grounded) as soon as
the calculated PWM value is above 50%. The function of the output then resembles
an on/off switch. It can be used to turn on/off lamps, relays etc.
Example
Set the entire PWM Load table to 100% (no load influence)
Set the PWM RPM table at 0% up to 6500 rpm and at 100% above this rpm.
This results in PWM_Out is off up to 6500 rpm, and on above 6500rpm. If you
connect a lamp between 12V and PWM_Out you now have an rpm-indicator lamp.
PWM1 RPM
The value 0-100% determines the PWM signals duty cycle in percentage depending
on rpm.
If you choose to control a boost control valve, then every PWM-value corresponds to
a specific boost. The boost for the different values differs and needs testing to be
determined.
Page 48