Download 08156SL

Jacking Instructions
CAUTION
2
When changing tires or performing other service, use suitable hoists and jacks to support
the ProCore Processor. Make sure machine is
parked on a solid level surface such as a concrete floor. Always chock or block wheels. Use
suitable jack stands to support the raised machine. If the machine is not properly supported
by jack stands, the machine may move or fall,
which may result in personal injury.
1. Position ProCore Processor on a level surface with
machine attached to tow vehicle. Engage vehicle parking brake, stop engine and remove key from the ignition
switch. Make sure that ProCore Processor engine is off.
Chock Processor wheels to prevent the machine from
moving.
1
3
Figure 1
1. Main frame
2. Lift axle bracket
3. Hitch pin
2. Secure lift axle to frame with hitch pin and lynch pin
to prevent lift axle from shifting (Fig. 1).
3. Position jack securely under the main frame. Do not
use the lift axle as a jacking point.
4. Carefully jack machine off the ground.
5. Position jack stands under the main frame to support
the ProCore Processor.
Securing ProCore Processor to Tow Vehicle
While operating or servicing the ProCore Processor,
make sure that ProCore Processor is properly secured
to tow vehicle. Refer to your Operator’s Manual and
Hitch Installation Instructions for the correct procedure
for attaching Processor to tow vehicle.
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the ProCore Processor. If any decal becomes illegible
or damaged, install a new decal. Part numbers for replacement decals are listed in your Parts Catalog. Order
replacement decals from your Authorized Toro Distributor.
Safety
Page 1 -- 4
ProCore Processor