Download Automatic Transmission Service

F3A2 - Transaxle
DISASSEMBLY
17004f
(1) Prior to disassembling the transaxle, plug all open/ngs and
thoroughly clean the exterior of the assembly, preferably by
steam.
(2) Place the transaxle on the workbench with the uil pan
down.
(3j Remove the torque converter.
(4) Measuring input shaft end play before disassembly will
usually indicate when a thrust washer change is required
(except when major parts are replaced). Thrust washers are
located between the reaction shaft support and rear clutch
retainer, and between the reaction shaft support and front
1
clutch retainer.
Mount a dial indicator to the converter housing using the
special tool, with its plunger seated against the end of the
input shaft.
Move the input shaft in and out with pliers to obtain the end
play reading. Be careful not to scratch the input shaft.
Record the indicator reading for reference when reassembling the transaxle.
(5) Remove the cover holder, and remove the cover.
(6) Attach the dial indicator on the transaxle case with the
special tool.
Measure the transfer shaft end play and record the indicator
reading.
(7) Remove the pulse generator “A” and “B”.
<MODEL 1992 only>
TSB Revision