Download Maintenance Procedures

Coin-In Handling
MAINTENANCE PROCEDURES: GAME KING PLUS
19" UPRIGHT
small denomination position uses two holes on the bottom and one
on the top, while the large denomination position uses two holes
on the top and one on the bottom (see Figure 6-11).
7. Fasten the rear encoder board and the encoder housing to the
comparitor channel with screws and tighten securely.
8. Replace the optic coin encoder assembly cover and connect the
harness to the front optic coin encoder board.
6.7.5
Diverter Disassembly and Assembly
The components that make up the coin diverter assembly include the
solenoid, solenoid plunger, cam and diverter plate (see Figure 6-8).
Disassembly
1. Remove the I/O cards from the I/O tray.
2. Remove the screws that hold the coin reject chute to the chassis
assembly.
3. Disconnect the diverter harness from the coin chassis harness.
4. Remove the screws that fasten the diverter solenoid to the coin
channel bracket.
5. Pull the diverter solenoid away from the coin channel bracket and
remove the solenoid plunger from the cam pivot pin.
Note: Be careful not to lose the compression spring on the plunger.
6. Remove the screw that secures the diverter cam and cam standoff
to the coin channel bracket.
7. Remove the diverter cam and cam standoff (or spring) from the
coin channel bracket. If one or more washers are present, remove
them. Remove the cam standoff (or spring) from the cam.
8. Place the coin handling assembly on a flat surface with the diverter
toward the bottom and facing up.
Note: For easy removal, insert a flat-blade screwdriver between the
diverter and the coin channel bracket. Carefully twist the screwdriver
until the pivot post clears the retaining hole in the bracket and lift the
diverter up. Be careful not to permanently deform the diverter or the
bracket during removal.
6-18
October 1, 2001